Home / Blog / Brentford

Brentford · Leak detection guidance

Leak detection in Brentford: why cross-check the meter serial and account?

Exact Source · 2 November 2026 · 2 min read

In a shared chamber or converted property, the nearest meter may not serve the expected address. A serial and account cross-check prevents a technically careful test being applied to the wrong supply. It should happen before isolation, logging or any estimate of water loss.

Build an identity record

Photograph the full chamber, each meter position and readable serial. Compare the target serial with a current bill or reliable supplier record, noting whether the bill uses actual or estimated readings. Record property identifiers without exposing unrelated account information in a widely shared report.

Ask affected occupiers about known shared supplies or past changes, but label their information as an account until verified. Do not infer ownership from pipe direction alone. Ofwat guidance distinguishes company and private pipe sections, while the actual arrangement may need supplier confirmation.

Test the association safely

Under an authorised plan, observe whether controlled use at a known outlet corresponds with the meter. Avoid wasteful flow and do not operate company apparatus or uncertain valves. Where several users may be connected, coordinate a no-use period and record who confirmed it.

Capture start and finish readings, units, times and interruptions. A moving display can indicate consumption on the measured supply; it does not locate the leak. A static short interval cannot exclude intermittent use or loss.

Keep account and defect conclusions separate

If the serial does not match, stop and resolve identity before further leak detection. Preserve the unexpected result because it may explain a billing concern. If identity is confirmed and unexplained flow persists, map the private boundary and commission proportionate location work.

After repair, repeat a comparable reading and record the pipe and test boundary. Give the supplier factual documents if requested, but do not promise a bill adjustment. The final pack should let a reader follow meter, account, test, defect and repair without treating any one item as proof of financial responsibility. Add the chamber position, meter make and display units to an index so later photographs can be matched even if labels change. Where the wrong meter was initially observed, retain that correction and tell every recipient who received the earlier reference. If a management company controls the chamber, record its access permission and the person responsible for future readings. A clean identity trail prevents a repaired leak on one supply being used to explain consumption on another.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist