A chalk mark or piece of tape can disappear before a follow-on contractor arrives. When a Camberley investigation narrows a concealed leak or proposed access area, the written record should let another competent person relocate it from durable features.
Choose references that will remain
Measure from two fixed features where practical, such as finished walls, a doorway edge, structural column or permanently installed fitting. Avoid using furniture, loose floor coverings or equipment as the only reference. State whether the measurement is to the centre of a marked area, an edge or a wider search zone.
Give the level as well as the plan position. A point on a wall needs a height from finished floor level; a point below a floor needs the room and storey above or below. Include orientation so that ‘left of the door’ does not depend on which way the reader is facing.
Photograph a wide view with the reference points visible, then a closer view of the mark. If a ruler is used, keep it in the same plane as the surface and do not obscure the defect.
Show confidence and the size of the area
Detection often identifies a zone rather than the exact dimensions of a failed component. Draw the boundary or radius that the evidence supports and distinguish a strongest indication from a guaranteed defect point.
Record the method and conditions that produced the location, plus any route uncertainty. A tracer signal, acoustic response or thermal contrast can be affected by pathways and construction; the final access decision should combine the evidence with service information and site risk.
If a buried service drawing is available, reference its title and date but verify the position before intrusive work. A sketch is a communication tool, not permission to drill or cut without checking for other services and hazards.
Update the record after opening
Once authorised access is made, record the actual opening and the confirmed defect position using the same references. Preserve the earlier proposed location so the file shows how closely the investigation guided the work.
HSE construction guidance stresses planning work and gathering relevant site information before it starts. Intrusive access should therefore be planned by competent people with appropriate service and material checks, not carried out solely from a mark in a report.
The completed location record can then support repair verification and reinstatement without forcing later teams to guess where the pipe section or access opening was situated.
Further reading
- HSE: planning for construction work
- Financial Ombudsman Service: information needed from financial businesses
Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.
Would you like to talk it through?
Tell us what you have noticed and request a callback for further information.
Speak to a specialist