Home / Blog / Cobham

Cobham · Leak detection guidance

Leak detection in Cobham: what should a ‘no leak demonstrated’ report contain?

Exact Source · 19 November 2026 · 2 min read

A visit can finish without demonstrating an active leak even when the original concern was reasonable. The water loss may be intermittent, the relevant circuit may not have been operating, or the symptom may have another cause. Good leak detection in Cobham should not turn that result into the broader claim that no leak exists. It should show what was tested, under which conditions, and what question remains open.

State the question the visit actually tested

The report should begin with the reported symptom and the agreed investigation boundary. A moving meter, falling boiler pressure and a ceiling stain are different questions. If the visit examined only the cold supply, its conclusion cannot clear a heating circuit, waste connection or rainwater route.

Record which outlets, valves and appliances were included, which were excluded and whether normal operating conditions could be reproduced. A reader should not have to infer the test boundary from a list of equipment.

Record negative results as evidence, not certainty

A stable meter during a controlled observation, a pressure reading that held for the test period or no repeatable acoustic response can all be useful. Each result needs its duration, isolation conditions and any relevant instrument setting. ‘Nothing found’ discards this information and makes comparison impossible.

The wording should remain proportionate: no active loss was demonstrated during the stated test. That is different from guaranteeing the pipework is sound at all times. Exact Source’s intermittent-leak guide explains why a dated event record can help prepare a return visit: https://exactsource.co.uk/advice/intermittent-leak-diary/.

Explain the unresolved alternatives

The report should name only alternatives supported by the evidence. These might include an intermittent outlet, a heating-system issue, residual moisture after an earlier escape, condensation or water entering from outside. A long generic list is less useful than two or three possibilities linked to the observed pattern.

If access, isolation or timing prevented a decisive test, say so plainly. HSE guidance emphasises planning work in proportion to the task and recording relevant arrangements; a defined limitation is safer than encouraging speculative opening work.

Give the homeowner a trigger for the next decision

A useful close-out note says what should prompt reattendance: a meter alert, pressure loss after a particular operating cycle, fresh visible water or a repeatable time-of-day pattern. It should identify what the homeowner can safely observe without dismantling fittings or pressurising systems.

For someone searching ‘cannot find my leak’, this is a meaningful outcome. The report preserves the completed tests, avoids a false all-clear and turns the next occurrence into better evidence rather than another unstructured search.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist