Home / Blog / Fleet

Fleet · Leak detection guidance

Leak detection in Fleet: what if pressure and meter evidence point in different directions?

Exact Source · 9 November 2026 · 2 min read

A property can have separate mains-water and sealed-heating systems, so a quiet meter and falling boiler pressure are not necessarily contradictory. During leak detection in Fleet, each instrument must be tied to the system boundary it measures. The report should reconcile the questions before treating one result as disproving the other.

Draw the two test boundaries

Map the meter-served supply and the sealed heating circuit, including filling connections, valves and appliances where known. Label uncertain cross-connections or shared supplies.

Record units, time intervals and operating states. A consumption meter and pressure gauge measure different properties and cannot be compared as the same quantity.

Test system-specific propositions

For mains water, use controlled quiet-period readings and confirm normal demand. For heating, record temperature, filling and pressure conditions under a competent test method.

Check whether filling-loop position, passing valves or user top-ups connect the observations. Keep these as hypotheses until valve tests or direct evidence support them.

Close each result independently

A stable water meter can narrow supply leakage while leaving heating loss open. A stable heating test does not explain unexplained metered use from another outlet or appliance.

If access confirms a defect, identify which evidence stream it resolves and repeat the relevant observation after repair. Do not claim both symptoms are solved without both outcomes.

For leak detection in Fleet, system-specific reporting prevents a valid result from being applied to the wrong question. Include a simple boundary diagram, test timelines and remaining actions. When a homeowner says the leak cannot be found, the distinction can reveal that two different concerns were being discussed under one label.

If the systems interact through a filling arrangement, record its valve position and any observed passing condition. Do not leave it open merely to maintain pressure during monitoring, because that can mask loss and affect metered use. The competent engineer should restore the intended configuration and document it. Ask occupants to record topping-up separately from ordinary water use. A later comparison can then distinguish heating make-up from unrelated supply consumption. State which gauge and meter supplied each figure. Keep both timelines on the same dated chart.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist