Home / Blog / Gerrards Cross

Gerrards Cross · Leak detection guidance

Leak detection in Gerrards Cross: how should water-company and private repairs be sequenced?

Exact Source · 12 November 2026 · 2 min read

An escape near a meter or boundary may involve water-company apparatus, a private supply or both. Leak detection in Gerrards Cross should map the observed sections and plan a repair sequence that preserves evidence. Work by one party can change pressure or meter behaviour before the other has completed its test.

Separate responsibility from physical evidence

Record meter identity, visible pipe route, valves, test boundary and the point where responsibility is believed to change. Label ownership information by source. Ofwat explains that supply-pipe responsibility can vary, particularly for shared arrangements, so the investigator should not decide it from pipe position alone.

Use the internal guide at https://exactsource.co.uk/advice/private-supply-responsibility/ to help the homeowner understand the general distinction. The site report should remain specific to the observed installation and avoid promising which organisation will accept a repair or bill.

Protect the baseline before either repair

Capture readings, operating conditions and physical indications before work changes the system. Identify which party needs the evidence and agree notification. If urgent action must happen first, record the make-safe state and what can no longer be tested afterwards.

Plan the order around isolation, access and the ability to verify each repaired boundary. A water-company repair may alter supply pressure; a private repair may stop meter movement. Those outcomes are useful only when the sequence and intervening water use are known.

Test and close each section separately

Obtain the relevant completion reference from each party and repeat the observation that applies to its section. Avoid using one party’s completion note as proof about pipework outside its work. Update the service map if exposure reveals the boundary in a different position.

For leak detection in Gerrards Cross, a sequenced record prevents overlapping work from erasing causation and outcome. The final report can show which escape was addressed, which meter behaviour changed and whether another section remains open, while responsibility and reimbursement stay with the appropriate decision-makers.

Where appointments overlap, nominate one person to maintain the shared timeline and control valve changes. Each contractor should still author its own technical findings. Record any water use between tests, because a meter difference cannot be assigned fairly without it. If a party removes a component or backfills an opening, preserve the relevant photographs and measurements before access to that evidence is lost. Keep supplier reference numbers and private job identifiers in the same cross-reference table.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist