Home / Blog / Harrow

Harrow · Leak detection guidance

Leak detection in Harrow: how should an intermittent overflow be logged?

Exact Source · 2 November 2026 · 2 min read

An overflow may run only during refilling, heating or a faulty control cycle, then stop before inspection. A log can identify the relevant event without asking the occupant to open a tank or defeat controls. It should show where water emerges and what was operating.

Identify the outlet and event

Photograph the external or visible discharge point with orientation and note date, start, stop, colour, temperature only if safely observed, and approximate continuity. Do not climb or reach into unsafe positions for a close-up. Mark which outlet is believed connected but keep that link provisional until traced.

Record nearby appliance, heating or water-use cycles and whether the same activity occurred without discharge. An overflow after heating may have different causes from a cistern that runs after flushing; a competent plumber should diagnose the actual control.

Preserve normal safety controls

Do not tie up floats, close warning pipes, cap outlets or alter safety valves. Do not repeatedly force filling to reproduce the symptom. If hot water, unsafe pressure or flooding is present, seek competent urgent assistance and follow equipment guidance.

A planned inspection can record water level, valve behaviour and system conditions without converting the homeowner into the tester. Identify access and authority, especially for communal tanks or plant.

Connect the log to repair verification

The report should state whether discharge was witnessed, the component confirmed and any alternative still open. Keep meter data separate: an overflow can contribute to use, but a bill alone does not identify it.

After repair, record the replaced or adjusted component and observe an appropriate operating cycle under competent control. Set a follow-up trigger if the event is rare. A dated log and closure note provide better evidence than simply stating that an overflow was ‘probably’ responsible. Keep the outlet clear and visible; do not conceal it as part of decoration. Give the occupant the component name, normal indication and urgent contact, but avoid asking them to inspect inside a tank. If the overflow served communal plant, the manager should retain the event log and notify affected users of any restriction. Later recurrence should be compared with the same operating condition, not assumed to have the same cause. Record the review outcome even when no further discharge occurs. State which operating cycles actually occurred during review.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist