A leak investigation involving two flats, a communal cupboard or a shared supply can produce evidence from several places at once. In Maidenhead, a clear report should make it impossible to confuse the property inspected, the system tested and the location where a symptom was observed.
Create a location key before recording evidence
Give each flat, communal area and plant space one consistent identifier. Use the postal address and the building's established unit number rather than an informal description such as ‘upstairs flat’. If numbering on doors differs from a managing agent's schedule, record both and explain the relationship.
Add a simple orientation note for repeated room names. ‘Flat 6, rear bedroom, wall adjoining Flat 7 bathroom’ is more useful than ‘bedroom wall’. Do not publish residents' names in the technical location key unless they are genuinely needed for the agreed purpose.
The same rule applies to meters and controls. Photograph the serial number or durable label where safe, then link it to the unit or system it is believed to serve. Ofwat advises checking that a meter's serial number matches the bill before relying on it for consumption information.
Link every result to its tested boundary
A pressure reading, isolation test or moisture observation should carry the relevant unit and system identifier. State whether the evidence relates to a private cold-water branch, communal supply, heating circuit, waste connection or another defined boundary. Avoid carrying a finding from one unit into the conclusion for another without explaining the connection.
If access to one flat was unavailable, make that gap visible. The report can identify the areas inspected and the areas not inspected without implying that the whole building was assessed. Record whether information about the unavailable area came from a resident, managing agent, earlier report or drawing.
Where the service route is uncertain, label it as uncertain and recommend the next proportionate check. A diagram can show a suspected connection with a dashed line rather than presenting it as confirmed.
Check identity again at handover
Before issuing the report, compare captions, readings, sketches and repair notes against the location key. A copied room label can send a follow-on contractor to the wrong property even when the underlying test was sound.
The ICO's records guidance recommends controlled record creation and accurate, retrievable information. For a multi-unit leak file, that means stable identifiers, a clear source for each fact and a correction process if a unit or meter is later shown to have been misidentified.
Professional assessment is needed where supplies are shared, ownership is disputed or isolation may affect other occupants. The identification record supports that work; it does not authorise interference with a neighbour's services.
Further reading
Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.
Would you like to talk it through?
Tell us what you have noticed and request a callback for further information.
Speak to a specialist