Home / Blog / Reading

Reading · Leak detection guidance

Leak detection in Reading: why should the report sketch the tested system boundary?

Exact Source · 2 November 2026 · 2 min read

A pressure result or isolation test has little meaning unless the reader knows which pipes were inside the test. For leak detection in Reading, a simple system-boundary sketch can distinguish heating from domestic water, private branches from shared supplies and accessible sections from pipework that remained connected or untested.

Name the system before drawing it

Start with the source and purpose: mains cold water, stored hot water, sealed heating circuit, underfloor loop or another defined service. Label relevant valves, meters, appliances and branches. The drawing can be schematic rather than to scale, but it must use consistent names that match the written report and photographs.

Show the point where the test boundary begins and ends. If a valve is believed to isolate a branch but its operation is uncertain, mark that uncertainty. Do not assume a closed handle proves complete isolation, particularly on a shared or poorly labelled installation.

Link readings to the boundary

Place each gauge, meter or observation point on the sketch and identify the timing of readings. Record connected equipment, refill paths and outlets that could alter the result. A pressure change on a defined heating circuit does not prove a defect in every pipe within the property, and a stable observation does not test systems outside the boundary.

If the layout is inferred from visible pipework or occupant information, use dashed lines and cite the source. Update the sketch after access reveals the real route. Keeping the earlier version shows how the investigation developed instead of rewriting uncertainty as if the concealed layout had always been known.

Use the sketch to plan the next decision

A negative result may lead to a different branch test; a positive result may justify more focused location work. The sketch helps the customer see why another system is being excluded or why an access proposal applies to only one route. It also reduces the risk of a later repairer testing a different boundary by mistake.

Ofwat explains that supply-pipe responsibility depends on the pipe and properties served. Ownership and technical test boundaries are related but not identical questions. Obtain professional help where a shared supply, communal plant or uncertain isolation could affect others, and record the authorised plan before operating controls.

Give every valve, meter and test point a label that matches the photographs and readings. A later reader can then tell whether two results concern the same boundary. If a label is provisional, say so and replace it once the route is confirmed.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist