Underfloor heating is not one undifferentiated pipe. Multiple loops, manifolds, controls and floor zones may behave differently. A circuit drawing helps isolate the investigation question and prevents a thermal pattern from being mistaken for an exact pipe route.
Start at visible, identifiable components
Label the manifold, loop names, valves, actuators, gauges and heat source using existing records and direct observation. Photograph labels before changing anything. Record whether names match actual rooms; old labels may be wrong after alterations.
Add visible pipe entries and available installation drawings. Mark all routes below the floor as recorded or inferred. Thermal images show surface temperature distribution under particular operating conditions, not pipe depth or defect identity.
Define the operating and test state
Record system temperature, pressure, pump state, active loops and elapsed time. A competent heating professional should decide isolation, pressure and commissioning steps. Do not override actuators, raise pressure or run a damaged system to make the route easier to see.
Link every reading or image to a loop and time. If one loop is isolated, confirm what else remains connected. Note background heat, sunlight and floor coverings that may distort patterns.
Use the drawing for conditional access
Combine repeatable pressure or loss evidence with mapped indications and construction information. Mark an access zone and explain confidence. Check floor services, asbestos information and structural or finish constraints before cutting.
After exposure, measure the actual pipe route from fixed points and record the defect before repair. Update the drawing, verification and return-to-service status. Give the owner the revised circuit record for future work, while making clear that unexposed loops were not certified by repair of one confirmed section. Add floor-finish and depth information only where it was actually observed. Record which loop was drained, refilled or balanced and by whom. The repair verification should identify cold and operating checks separately, plus any manufacturer procedure followed. Keep drying and reinstatement decisions outside the circuit test unless those services were expressly commissioned. Before access, agree the coordinate origin and measurement units so the final drawing remains usable after decoration. Photograph the manifold labels and retain the earlier version if any loop name is corrected. Add a note for any zone that was unavailable, inactive or controlled by a separate thermostat during the investigation, because its absence limits the comparison.
Further reading
Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.
Would you like to talk it through?
Tell us what you have noticed and request a callback for further information.
Speak to a specialist