Home / Blog / Sandhurst

Sandhurst · Leak detection guidance

Leak detection in Sandhurst: how should a shared isolation be documented?

Exact Source · 9 November 2026 · 2 min read

A valve that appears to serve one property may interrupt another flat, outlet or safety-critical use. During leak detection in Sandhurst, the isolation record should therefore identify the tested boundary and the people affected before a result is interpreted. A pressure change is useful only when the actual service state is understood.

Establish the isolation boundary before turning the valve

Trace labels, accessible pipework and available drawings, then ask the responsible person which outlets are believed to depend on the valve. Mark assumptions separately from confirmed connections. A valve position alone cannot prove the concealed extent of a shared supply.

Record the initial state, meter reading and any essential uses that must remain available. Notify affected occupants through the authorised contact and agree the test window. If the boundary cannot be established safely, use a narrower observation or obtain further information rather than causing an unplanned interruption.

Log the change and observe both sides

Note who operated the valve, its identifier, time, direction and final position. Check the intended outlet and, where authorised, representative outlets outside it. A partial closure, passing valve or cross-connection can make a seemingly clear result misleading, so include unexpected continuity in the record.

Ofwat explains that responsibility for supply pipes can depend on where they run and whether they serve more than one property. The technical test should not decide legal responsibility, but it should preserve the observed arrangement so the relevant owner, water company or managing party can assess it correctly.

Restore service and qualify the conclusion

Return the valve to the agreed state, confirm service at the checked outlets and record any air, discolouration or fault requiring attention. If normal service cannot be restored, escalate to the responsible competent party rather than leaving a note for occupants to discover later.

For leak detection in Sandhurst, the report should say which section was isolated, what changed and what remained live. A fall in meter movement may narrow the search without proving the exact defect. Keep the notification and restoration entries with the test so a later reviewer can distinguish a valid zone result from an interruption whose true boundary was never confirmed.

Where another property was affected unexpectedly, add a correction to the service map and notify its responsible contact. That new fact should shape any repeat test and repair shutdown, reducing the risk of reproducing the same unplanned interruption.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist