Home / Blog / Southall

Southall · Leak detection guidance

Leak detection in Southall: what evidence should be checked after a high water bill?

Exact Source · 2 November 2026 · 2 min read

A high bill can reflect usage, estimated readings, account errors or leakage. The first step is to establish what the bill and meter actually show, not to choose an excavation point. A short evidence checklist helps the water company, consumer and leak specialist address the same period.

Check account and reading history

Record bill dates, whether readings are actual or estimated, units, meter serial and any tariff or occupancy change. Compare photographs of the current display with the billed serial. Ofwat encourages consumers to understand meter identity and regular readings, especially where use is difficult to predict.

Build a timeline of unusual use, vacancy, building work, irrigation, appliance changes or known incidents. Use actual records where available and avoid inventing a daily leak volume from one large bill.

Observe flow under controlled conditions

Agree a safe no-use period covering all properties and appliances on the measured supply. Photograph start and finish readings with times. Do not operate unfamiliar or water-company valves. If the supply is shared or the meter identity uncertain, contact the water company or use competent help.

A moving meter supports further investigation but does not locate the loss. A static short test does not exclude an intermittent event. Repeat or log only where the interval and operating conditions answer a defined question.

Choose the next route from the evidence

Map the meter, responsibility boundary and likely private route using records and Ofwat guidance. Check visible toilets, overflows and appliances through safe competent inspection before assuming an underground leak. Keep results for each branch separate.

If private loss remains likely, commission leak detection with a defined boundary and access decision. Share the factual pack with the supplier if seeking an adjustment, but do not promise eligibility. The final report should state confirmed defect, repair date and verification without deciding the account outcome. Keep a copy of the reading submitted to the supplier and the date it was sent. After repair, take a comparable no-use reading under recorded conditions. If consumption remains unusual, reopen the usage and meter questions instead of assuming the repair failed or that a second hidden leak must exist. Note any estimated bill later replaced by an actual reading, because that change can explain part of the apparent difference without changing the technical leak evidence.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist