Home / Blog / Surbiton

Surbiton · Leak detection guidance

Leak detection in Surbiton: is the loss on an external branch or the house supply?

Exact Source · 2 November 2026 · 2 min read

When a private supply divides before entering the house, unexplained meter flow does not show which branch is losing water. A staged plan first confirms meter identity and legitimate use, then uses safe, competent isolation to compare the external and house boundaries.

Draw the known distribution

Mark the meter, boundary, internal entry, visible tees, outside taps, irrigation, outbuildings and valves. Cite plans and occupant information, and show inferred buried routes differently. Check for shared supply and water-company apparatus before operating anything.

Photograph controls with fixed references. A valve location near one branch is not proof of what it isolates. If labels are absent or behaviour is uncertain, make valve identification a separate task.

Compare controlled observations

Agree a no-use interval covering every user on the meter. Record readings, times and interruptions. A competent person can then isolate a verified branch where safe, with affected users informed. Preserve each result and the exact valve state.

Partial isolation, passing valves or intermittent irrigation can invalidate the comparison. State that clearly and repair the test dependency before excavating. Do not estimate a precise leak point from flow alone.

Locate and verify the indicated branch

Use route information and proportionate leak methods to narrow the supported branch. Mark an excavation zone, check buried services and obtain land authority. Set stop criteria if the pipe or ground condition differs.

After repair, record pipe identity, defect and pressure or flow verification. Repeat the whole-supply observation under comparable conditions. Report the untested branch honestly; confirming one external defect does not certify the house distribution, and a house result does not rule out seasonal outside use. Where the excavation crosses a garden feature, agree reinstatement and photograph existing condition before work. Mark the repaired route from two fixed points so later digging can avoid it. If the branch is abandoned rather than repaired, record the permanent disconnection and update valve labels. Give the owner a clear future no-use test that includes every remaining measured outlet. Record depth and material only where exposure confirmed them. Preserve the isolation sequence, including any passing valve. Give the reinstatement party the marked route and repair-test result before backfilling, and photograph the protected pipe. Record surface restoration and any later settlement review separately. Keep the final marked route with the property maintenance record.

Further reading

Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.

Would you like to talk it through?

Tell us what you have noticed and request a callback for further information.

Speak to a specialist