A private supply may branch to an outside tap, irrigation system, outbuilding or other feature before entering the house. If that branch is not named, a house-only test can be mistaken for a whole-property result. The scope should show every known branch and what remains untested.
Map the distribution from reliable points
Identify the meter, internal entry, visible tees, valves and external outlets. Use bills, plans and occupant information, labelling each source. Photograph chambers and controls in context. Do not assume an isolated-looking garden valve belongs to the commissioning property.
Mark buried routes as inferred until tracing or excavation confirms them. Consider shared supplies and the Ofwat responsibility framework. Water-company records or assistance may be needed before operating apparatus or assigning ownership.
State branch inclusion and test conditions
The quotation should list each external branch included, inaccessible or excluded and the method proposed. Record seasonal shutdown, irrigation controllers, frost protection and appliance use that could affect observations. A no-flow meter test needs all measured users to be controlled.
If a valve fails to isolate, report that limitation and arrange competent correction before interpreting the branch. Do not excavate solely from a moving meter; narrow the route and account for legitimate outdoor consumption.
Report outcomes by branch
Show which boundary lost pressure or flow, under what conditions, and which branches were not assessed. If evidence indicates an external zone, mark it with fixed references and define the excavation stop point. Check services and land authority before digging.
After repair, record the pipe identity, defect, test and reinstatement. Keep the internal house result separate. This gives a homeowner searching for leak detection near me a precise answer about the outside branch without claiming that every private pipe on the property has been examined. If the branch is deliberately abandoned, document the disconnection point and how dead ends or future confusion are addressed by the competent installer. Update any irrigation or outbuilding instructions. A later meter check should repeat the same controlled conditions so it verifies the changed boundary rather than introducing new users into the comparison. Mark any external valve left closed and tell the authorised user when it may be reopened. If frost or weather affects timing, record that limitation rather than extending the leak conclusion beyond the actually observed conditions.
Further reading
Prepared with AI assistance using the sources listed above. General information cannot diagnose an individual property. Contact us to discuss your circumstances.
Would you like to talk it through?
Tell us what you have noticed and request a callback for further information.
Speak to a specialist